Janome Quilt Maker Pro 18 VERSA - Timing - Adjusting Loop Lift and Needle Distance; Helpful Notes Before Proceeding; Adjusting Loop Lift and Needle Distance

Janome-America.com
Page 23
13. Timing - Adjusng Loop Li and Needle Distance
Helpful notes before proceeding;
Note 1: Some hooks are ghter than others on the
hook-sha. You may be tempted to pry on the hook
mechanism. If you pry on the hook it may become
damaged, irreparable and unusable.
Note 2: Once the basket has been turned down it must
be held while turning the hand wheel to prevent it
from turning and colliding with the needle.
Note 3: When the hook screws have been loosened,
the adjustments of the loop li and needle distance
are possible since the hook can be moved radially as
well as axially.
Note 4: If needle height is not set roughly close rst,
it will not be possible to set needle distance correctly
because needle distance is set so the hook point lightly
brushes inside the needle scarf.
Adjusng Loop Li and Needle Distance:
1. If sll in place from the check, remove the clamp.
Make sure the basket is rotated down.
2. Loosen the two screws on the hook base. (2 mm
handle hex tool) Replace the clamp and reset with
the 2.2 feeler gauge as described in Secon 11:
Timing - Checking Loop Li and Needle Distance,
making sure to turn the hand wheel in the direcon
of moon.
3. Set the hook to the correct posions by sliding
the hook axially (needle distance) on its sha, as
well as radially (loop li), seng the hook point
relave to the needle, as described on the next
page. For radial posion of loop li see Figure
13.1 above.
Figure 13.1
Loop li and needle height both set correctly
Figure 13.2
Needle guard
Figure 13.3
Hook screws