Janome Quilt Maker Pro 18 VERSA - Adjusting the Needle Height with Cylinder Tool - Continued; Comparing Eye Levels with Cylinder Groove; Reinstalling Hook and Setting Loop Lift; Electronic Adjustments and Indicators

Janome-America.com
Page 29
16. Adjusng the Needle Height with Cylinder Tool – Connued
Figure 16.5
Figure 16.6
17. Electronic Adjustments and Indicators
System Power
The Quilt Maker Pro 18 VERSA operates at voltage
levels between 100 and 240VAC, 50 or 60 Hz. This
means it can be run in most countries as long as the
appropriate power cord or adapter plug is used. If
an adapter plug is used, please be sure the adapter
connects the Earth Ground as well as the Line and
Neutral prongs of the plug. An improper or non-
existent earth ground connecon will lead to sporadic
and potenally dangerous operang condions of the
machine.
4. Slide the cylinder tool gently against the needle (Figure 16.5).
5. Sight through the needle eye and compare the upper and lower levels of the eye with the cylinder tool
groove (Figure 16.6). If an adjustment is necessary, loosen the needle bar driving clamp slightly and raise or
lower the needle bar.
6. Reinstall the hook and set loop li at 2.2 mm and reset needle distance. (See Adjustment of the Loop Li
and Needle Distance Secon)