Janome Quilt Maker Pro 18 VERSA - Control Board; Control Board Location and Connections; Unused Control Board Connections

Janome-America.com
Page 33
Control Board
The Quilt Maker Pro 18 VERSA machine has the control board mounted inside the main front cover casng.
The main control board uses the following 8 connecons (all are labeled with the name except the
handlebars which are labelled J18 and J 17):
• RED/BLK power connecon - top right of board
• Encoder, speed needle sensor for main sha
• Motor Driver
• Handle Bar Connecon (J18)
• Handle Bar Connecon (J17)
• Power (for handle bar remote power switch)
• Tension (for front display readout)
• Lighng (for built in light ring)
The three circled connecons below are not used on the control board: Test, Thread Sensor and Speaker