Janome Quilt Maker Pro 18 VERSA - General Observations and Checks - Continued; Thread Guide Inspection

Page 8
Quit Maker Pro 18 VERSA
Figure 1.4
3. Check/Inspect: Test the condion of the thread
guides, the takeup/check spring, the take-up
lever, the thread srrup and the needle bar
thread guide. Check for any abrasions, cuts, or
electroplang blistering. Test each guide by ossing
it with thread, le to right and front to back in all
direcons, checking for any sharp defects that may
damage or cut the thread. Replace any damaged
parts.
1. General Observaon - Connued