AAA-055-00138 Rev. 1/14/15
Jaylor Owner Manual - 58 - Mini Mixer Models
e. Fill the reservoir with qualified oil. Be sure to fill to the height specified in Figure 44 for A50
models and Figure 45 for A100 models. Remember, the reservoir holds approximately 8.5
US gallons (32 liters) for A50 models and 14 US gallons (53 liters) for A100 models.
f. Remove the spin-on oil filter(s) and dispose of the filter in an environmentally safe manner.
Locations are outlined in Figure 46, Figure 47, Figure 48, and Figure 49. Remember, all
A50 models come equipped with one (1) spin-on filter while all A100 models come equipped
with two (2) spin-on filters.
g. Install new spin-on filter(s) (contact Dealer/Distributor for filter specifications).
h. After running the system for a few minutes at low idle, check the oil level in the reservoir
again and top up if necessary.
Figure 46 - A50 Self-Propelled Hydraulic Oil Filter Location
1. Spin-on Filter Element - Rotating the element counterclockwise by hand will release the
element from the filter head. Likewise, rotating the element clockwise will tighten it.
2. Filter Head
NOTE – Hydraulic fittings and hoses in this figure have been removed for clarity.
To Next Page
Loading...
