128
This setting is for putting sanitizer into the fresh water tank (refer to
sanitize tank and country ll diagram).
Black valve should be turned so it points to the clear suction hose.
White valve should be pointing left toward the water tank as shown.
Place the clear suction hose into a container of
sanitizer solution. Turn the pump switch ON and
sanitizer will be drawn into fresh water tank.
This setting allows you to ll the
fresh water tank from a container of water in the absence of a pres-
surized water source.
Black valve should be pointing to the clear suction hose.
White valve should be pointing left toward the water tank.
This setting is identical to the setting. Instead
of placing the clear hose in a container of sanitizer, place it in a
container of fresh water.
Turn water pump ON and water will be siphoned out of the container and into the fresh water
tank. .
Most oor plans have a factory installed water
heater bypass that enables you to avoid lling the
water heater with RV antifreeze. Bypass valves
are typically located in close proximity to the wa-
ter heater. Outside utility centers (if so equipped)
operate dierently than a factory installed bypass
system. Refer to the Outside Utility Center sec-
tion for details.
operation allows water to ow into the water heater. Hot water bypass valve
handle (B) should point toward the water heater. Cold water bypass valve (A) should point
toward the water heater.
Utility center blue valve position does not matter as it is not used
for sanitizing.
Make sure you have sufcient
12V power and all drain valves are
closed to create a siphon.
To Next Page
Loading...
