93
○ RV Auto Leveling systems
○ Power Jacks and Stabilizers
○ Interior and Exterior Lights
○ RV Slide-out Rooms
○ Power Awnings
○ Generator
○ TV and Bed Lifts
○ HVAC thermostat
○ Gas and Electric water heaters
○ Fresh Water, Black water, Gray water tank levels
○ Battery levels
○ Back up camera systems
○ Water pump
○ Kitchen and bath vents and vent covers
○ Door locks
○ TV, radio and DVD systems
○ Automatic Fireplace control
○ Lowering/raising the automatic ramp door
(toyhauler)
The system has a downloadable app available for your
smartphone, tablet or smart device called RVMaster. The
app is available through the App Store (iPhone) or Google
Play Store (Android).
The system will come with 4 (or 5 - depends on oorplan)
individual smart remote controls (or RVMasterSwitches)
which can each be programmed for individual room con-
trol. The remotes are installed on the wall of the RV in each room.
Remote controls come paired to your system from the factory.
If remotes get “un-paired” from the RV Bluetooth system, press the
arrow keys at the bottom of the touchscreen until PA appears in the
Menu Display. Then press the RET button, the display will blink on
and o indicating the system is ready for pairing. Then press and hold
any two buttons on the remote control. The PA display will go out
when pairing is complete. The remote will now be able to operate the
systems labeled on the individual buttons for that specic room and
remote.
The RVMasterSwitch remote controls use a 3V Lithium
CR2032 coin cell battery.
To remove the remote from the wall:
○ Pull the bottom of the remote away from the
wall . There will be an audible snap as
you release it from the clip.
○ Lift the remote upwards to unhook it at the
top.
○ The remote will separate from the wall
mount (.
To Next Page
Loading...
