71
VTX A8 | Rigging Manual
14.2 STORAGE POSITION
The two angle selection plates can be removed from their normal positions and placed in a storage location. The M20 knob is used to
secure the two angle selection plates onto the base plate.
14.3 ANGLE SELECTION PLATES
The Base Plate angle selection plates include nine pin positions, allowing for a range of angles from -15 to +5 degrees in 2.5-degree
steps. This facilitates selection of the most appropriate position for establishing the required array down angle. JBL’s Line Array Calcu-
lator software is used to determine the best position and check array safety.
-15°+5°
To Next Page
Loading...
