52
VTX A12 | Rigging Manual
12 - THE VTX DELTA PLATE
The VTX Delta Plate is a rigging accessory used for controlling the horizontal aiming of an array. Two chain motors are attached to the
Delta Plate, allowing for adjustments of up to +/- 10 degrees. The VTX Delta Plate can also be used to distribute the weight of an array
to two points.
12.1 USING THE VTX DELTA PLATE
The VTX Delta Plate is typically positioned at the rear of an array and connected to the very last attachment hole of the Extension Bar.
The included 5/8-inch shackles are used to connect the VTX Delta Plate to the Extension Bar. Two rear motors are connected to the VTX
Delta Plate, and horizontal aiming of the array is achieved by adjusting the position of the rear motor points.
To Next Page
Loading...
