258 MULTIMEDIA
Uconnect 3 With 5-inch Display
Uconnect 4 With 7-inch Display
NOTE:
You must have Bluetooth® enabled on your
phone to complete this procedure.
The vehicle must be in PARK or at a standstill.
Follow the steps below to pair your phone:
1. P
lace the ignition in the ACC or ON/RUN
p
osition.
2. Press the Phone button.
N
OTE:
If there are no phones currently
connected with the system, a pop-up will
appear asking if you would like to pair a
mobile phone.
This pop-up only appears when the user
enters Phone Mode and no other
device(s) have previously been paired. If
the system has a phone previously
paired, even if no phone is currently
connected with the system, this pop-up
will not appear.
3. Select “Yes” to begin the pairing process.
4
. Search for available devices on your
B
luetooth®-enabled mobile phone.
Press the Settings button on your mobile
phone.
Select “Bluetooth®” and ensure it is
enabled. Once enabled, the mobile
phone will begin to search for Bluetooth®
connections.
NOTE:
During the pairing procedure, you may receive a
po
p-up on your touchscreen asking you to make
sure the PIN on the touchscreen matches the
PIN from the pop-up on your mobile phone.
5. If “No” is selected, and you still would like to
p
air a mobile phone, press the Pairing or
Settings button from the Uconnect Phone
main screen.
Press the Paired Phones button.
Search for available devices on your
Bluetooth®-enabled mobile phone (see
below). When prompted on the phone,
select “Uconnect” and accept the
connection request.
6. Uconnect Phone will display an in-progress
s
creen while the system is connecting.
7. When your mobile phone finds the
U
connect system, select “Uconnect.”
8. When prompted on the mobile phone,
a
ccept the connection request from
Uconnect.
To Next Page
Loading...
