SERVICING AND MAINTENANCE 425
2. Turn the socket assembly a quarter turn
counterclockwise and remove from
housing. Pull the bulb straight from the
socket to replace.
LED Front Side Marker
See below steps to replace:
1. R
emove the front wheel liner fasteners to
a
ccess side maker screw and electrical
connector.
2. Remove fastening screw in the back of the
f
ront side maker assembly and disconnect
electrical connector.
3. Remove and replace LED front side marker
l
ight assembly.
Front Fog Lamp
NOTE:
We advise seeing an authorized dealer for
se
rvice on LED and Halogen front fog lamps.
See below steps to replace:
1. R
each under the vehicle to access the
b
ack of the front fog lamp.
2. Disconnect the wire harness connector
f
rom the front fog lamp connector
receptacle.
3. Firmly grab the bulb by the two latch
f
eatures and squeeze them together to
unlock the bulb from the back of the front
fog lamp housing.
4. Pull the bulb straight out from the keyed
o
pening in the housing and then connect
the replacement bulb.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps
th
ey are replaced as an assembly.
Rear Tail, Stop, Turn Signal, And Backup Lamp
See below steps to replace:
1. R
emove the two screws that pass through
t
he bed sheet metal.
Tail Lamp Screws
2. Pull the outboard side of the lamp rearward,
f
ar enough to unsnap the two receptacles
on the outboard side of the lamp housing,
from the two plastic snap post retainers in
the outer box side panel.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
8
To Next Page
Loading...
