GETTING TO KNOW YOUR VEHICLE 69
Resetting Your Jeep® Wireless Speaker
To reset the Jeep® wireless speaker to its
original factory setting, press and hold the reset
button under the back cover for 8-10 seconds.
Speakerphone
The speakerphone feature can be used by
pressing the “Voice Control” button on the
Jeep® wireless speaker. This feature can be
used to answer and end calls over the
speakerphone.
Volume And Playback Control
Volume can be increased or decreased by
briefly pressing the + button or - button. When
the maximum volume is reached, an audio cue
will sound.
To skip to the next track, press and hold the +
bu
tton. To go to the previous track, press the -
button.
Qualcomm TrueWireless™ Stereo
A feature of the Jeep® wireless speaker is being
able to pair two Jeep® wireless speakers
together for Qualcomm TrueWireless™ Stereo.
This feature allows for two Jeep® wireless
speakers to play left and right stereo sound.
Below are the steps needed for Qualcomm
Tr
ueWireless™ Stereo:
1. Push and hold the power button on both
J
eep® wireless speakers until both
speakers turn on.
2. Place both speakers into Qualcomm
T
rueWireless™ Stereo pairing mode. This
can be achieved by pressing and holding
the Battery Status button on both speakers
until an audio notification is heard from
both speakers.
3. Connect one of the Jeep® wireless
s
peakers to the Bluetooth® source. Refer to
previous section “Phone & Bluetooth®
Pairing” for additional information.
4. Once the Jeep® wireless speaker is
c
onnected to the Bluetooth® device, audio
will be played from both speakers.
NOTE:
While in Qualcomm TrueWireless™ Stereo mode,
th
e volume will not have independent speaker
control. Pushing the Up or Down Volume button
on either Jeep® wireless speaker will affect the
audio output on both, as well as volume adjust
-
ments on the Bluetooth® device.
Waterproof Features
The Jeep® wireless speaker is IP67 waterproof
certified with design in mind to withstand
rainfall, waterjets, splashing or submerged in
up to 3
ft (1 m) of water for up to 30 minutes.
Warnings, Caution & Legal Information
To reduce the risk of fire or electric shock, do
not expose the Jeep® wireless speaker to rain
or moisture while charging. The Jeep® wireless
speaker should not be exposed to dripping or
splashing, and objects filled with liquids, such
as vases, should not be placed on or near it
while being charged or charging other devices.
As with any electronic products, use care not to
spill liquids into any part of the product. Liquids
can cause a failure and/or a fire hazard. The
power supply must be used indoors only. Make
no modifications to the product or accessories.
CAUTION!
Ensure the Jeep® Wireless Speaker is pre-
pared for use in wet environments by remov-
ing all cable connections and making sure all
p
o
rt covers are sealed tightly. If the cover is
not secured properly, the Jeep® Wireless
Speaker may sustain water damage.
2
To Next Page
Loading...
