Page 18 of 97
2-SAFETY INFORMATION
______________________________________________________________________________________________
→ Rotate the mushroom-shaped button in the direction indicated by the arrows printed on it;
→ The push-button is now backing in service and the machine is ready to work.
→ Push the turn on engine button to start-up the machine
2.6 Daily check
Daily checks to be performed before starting the machine:
o Check hydraulic oil level
o Verify there is no visible oil leakage
o Check safety micro-switch. Remove possible mud, grease, etc. residues without using
metal tools.
o Test safety systems
o Carpentry condition visual check
o Check outriggers efficiency
o Verify safety labels are present and readable
o Make sure the working area is ventilated as batteries produce explosive gases
o Check greasing of the machine
o Check oil level engine
2.7 Features of the working area
To avoid unpleasant troubles or even accidents working areas have to meet specific requirements
such as:
o Enough space to allow outriggers setting according to the different handling necessities
o Ground slope smaller than 5 %
o The foots of the outriggers must lay on solid ground, without manhole, cover, etc.
o Check power supply availability at the voltage required by the machine and in
conformity with the rules in force.
In case the machine has to work on upper floors, verify their maximum
loading capacity according to what indicated in paragraph ‘Technical
Specifications’.
CAUTION!!!
Don’t work on floors without having verified their loading capacity. The
manufacturer declines any responsibility arising from damage or
collapse.
2.8 Working in bad weather conditions
CAUTION!!!
It is forbidden to work with the machine in case of wind or storm
condition.
To Next Page
Loading...
Need help?
General
