Page 11 of 97
1-PREFACE
______________________________________________________________________________________________
Double line pull Triple line pull
1.3 Original Seals
The manufacturer has placed lead sealings on machine components to assure working under safe
conditions.
ORIGINAL SEAL REMOVAL WILL CAUSE MACHINE UNSAFE WORKING.
THE MANUFACTURER DECLINES ANY RESPONSIBILITY ARISING
FROM UNSAFE USE OF MACHINES.
1.4 Operator Training
Technical training is required to the operator in order to correctly operate this machine. ORMET
SPA qualified personnel is available to train your personnel in many European countries. Contact
your dealer for more information. If you can not find a dealer in your country please call ORMET
SPA.
1.5 Intended use
The machine has been designed to handle loads by means of a lifting hook, a winch or an
accessory jib: loads must not exceed the load diagram printed or labelled on the crane. The
models SPD265C+ _SPD266C+ _SPD360C+ are intended for internal use only.
To Next Page
Loading...
Need help?
General
