Page 71 of 97
9 – STANDARD OPERATOR
MAINTENANCE
______________________________________________________________________________________________
At the end of the working day or when the machine will be laid up for
long periods, remember to disconnect the battery switch in order to
avoid run the batteries completely down.
Battery charger (C+)
• To avoid overheating, check that all the cooling clefts are not clogged.
• Protect the battery charger from possible water sprays.
• Make sure that the available power supply corresponds to that indicated on the battery
charger identification plate.
• If an extension or a multiple jack are used, make sure they are suitable to the overall
voltage required.
• Turn off the power supply before connecting or disconnecting plugs.
• In case of lead-acid storage battery charging WARNINGN!!!:EXPLOSIVE GASES >
keep flames and sparks away. Battery must be located on a ventilated area.
• Do not use the battery charger to charge batteries of hot-air engine cars.
• Only rechargeable batteries can be charged.
• Check battery voltage is the same indicated on battery charger identification plate
• Don't try to repair the battery charger: the cover opening may cause danger of electrical
shock
• If the battery charge does not work correctly, unplug it immediately from the main and
from the battery and apply to the seller.
Battery (C+)
• Always wear individual protective clothing such as safety glasses, gloves, etc. when
performing battery maintenance.
• Never add acid to the battery.
• Do not expose to extreme heat or open flame.
• Make sure electrolyte covers are close
• Keep the battery clean and dry.
9.3 How to increase the battery lifetime
Charging
• Re-charge battery after each usage.
• Verify electrolyte level is over the plates.
• Tighten vent caps before charging;
• Do not interrupt charge cycle;
• Never charge a frozen battery.
• Perform re-charging in ventilated areas only.
Topping-up
• Add water only after have completely re-charged the battery;
• Never let the electrolyte level falls below the plates;
• Use distilled water or water with low mineral content.
To Next Page
Loading...
Need help?
General
