2. CONNECTION TO TRACTOR
PR11-5000
Fig. 2-9
Fig. 2-9 Shorten all 4 tubes equally. The shortened ends of the profile tubes must be
deburred and cleaned of dirt and swarfs and the profile tubes must be lubricated
before the PTO shaft is reassembled.
F. On the PTO drive shaft between the 3-point suspension and the machine there
is a friction clutch which ensures that the machine is not overloaded during
operation. Before starting a new machine, the clutch must be "aired". See
section concerning the friction clutch in chapter 6 "MAINTENANCE".
G. The 3-point linkage frame is mounted in the lift arms of the tractor. The L-frame
hoop 3 is pushed onto the 3-point linkage frame 5.
You should read and observe the instructions in the instruction manual for your
tractor as regards connection of implements in the tractor hydraulics. You should be
especially aware of the fact that if the tractor hydraulics is with weight transfer that is
activated by the top link fix point, the weight transfer must be put out of action or the
top link must be connected to a firm top point on the tractor. If the weight transfer is
not put out of action, the link arms may begin to lift even if the control handle is not
activated. The weight transfer may also cause the link arms to move heavily up and
down.
PIGB-138X-02 FC 855 0410
- 26 -
To Next Page
Loading...