MNP11M01GB06 May 2007- Rev.4 Page: 14 de 40
4.- PROGRAMMING ADDRESSES. ACCESS LEVELS.
Not all of the addresses of the programming mode are directly accessible, nor are
they available in all models. They are divided into three access levels. To access the
addresses of the second level a code must be introduced in address 50 (or address
60 if you want to get into the third level).
Some addresses will appear only when the compact is running under one of the two
protocols available (MDB or Executive). To select the protocol you have to go to
address 65.
: This address appears when the compact is running under Executive
protocol (address 65 at 0).
: This address appears when the compact is running under MDB protocol (
address 65 at 1).
Some addresses can be shown at a level, but can only be modified at a greater level.
The addresses that can be accessed in the first level are the following:
101 to 199: Price programming. è
21 : Coins in the change tubes. è
25 : Reloading the change tubes. è
27 : Consulting and resetting breakdowns. è
50 : Access code to the second level. è
68: Version of programme. è
The addresses that can be accessed in the second level (including those that belong
to the first level) are the following:
00: Maximum recovery/maximum credit.
1101 a 1199: Nº of sales of each price. è
22 : Coin programmed in the tubes. è
23: Other coins programmed in the tubes. è
24 : Configuration of RS232 to the printer. è
26 : Unloads from change tubes. è
28 : Clock / calendar. è
29 : Programming of maximums at tubes. è
30 : Retention and display of prices. Mode of sale. è
31 : Automatic unload from change tubes. è
34 : Coins inhibited when out of sale mode. è
35 : Number of coins to go into out of sale mode. è
38 : Inhibition of individual coins and tokens. è
42 : Sales with discount. è
44 : Tokens value. è
48 : Base currency. è
49 : Promotion schedule. è
51 : Checking of the validator. è
52 : Type of protocol. è
53 : Coin in external tubes. è
55 : Note reader options. è
56 : Note reader inhibitions. è