MNP11M01GB06 May 2007- Rev.4 Page: 28 de 40
2201-> Total counts of price 1.
....
1299-> Partial counts of price 99.
2299-> Total counts of price 99.
Pressing “2” we can select between 1201 and 2201 addresses.
“__67” RECORDING A NEW COIN IN THE COMPACT.
In this address it is possible to record a new coin in the compact. Before to record a
new coin, it will be neccessary that this coin had been recorded in the validator. To
record a new coin is neccessary the next steps:
1.- Go to address 0_67 push buttom 3 appears 2 lines and insert the coin in
the validator, and will appear the code of the new coin.
2.- Go to address 1_67 push buttom 3 y shows the code of the coin that will be
recorded.
3.- Go to address 2_67 and programme the value of the new coin, to
reprogramme is like address 50.
4.- Go to address 3_67 and reprogramme the capacibility of the coin in tubes.
The inhibitions are calculated automatically.
“__68” VERSION OF THE PROGRAMME.
In this address is possible to see the version of the programme, and appears in
the first level programming.
“__70” a “__81” SALES COUNTS
The addresses that go from __70 to __81 allow an exhaustive control of the use of
money introduced into the J-2000.
To consult the value accumulated in one of these addresses press “3”. The J2000 will
show the money accumulated on the display as a 7 digit number, the three highest
digits first and a few seconds later the other four.
For example, if 12500 PTAs has been entered into the cashbox, the display will show
1 and two seconds later 2500.
The accumulated value is reset to zero automatically on reaching the sum of 10
million. For example, if the count is at 9999950 and it accepts a coin of 100, the count
will become 50.
This addresses have two fields. Pressing “2” we can select the field, and pressing “3”
see the contents.
"1_XX" : partial counts.
.....
"2_XX" : total counts.
If the compact is running under the MDB protocol only the marked (*) addresses will
appear. The sales counts that the J-2000 carry out are the following:
70(*) : Money directed to interior change tubes.