MNP11M01GB06 May 2007- Rev.4 Page: 27 de 40
“__56” INHIBITION OF NOTES
1_56: Inhibition of notes 1 to 4.
2_56: Inhibition of notes 5 to 7.
3_56: Programming of inhibition of notes in out of change.
“__60” ACCESS CODE TO THIRD LEVEL
To access the third programming level the access code must be introduced here. To
enter code do it in the same way as in address 50.
“__61” IDENTIFICATION NUMBER
A six digits identification number is programmed.
“__62” DATE OF MANUFACTURE
The month and year of manufacture is programmed. For example, if the compact was
made on July of 1996 the code 0796 will appear on the display.
“__63” COUNTRY CODE
The country code can be visualised (For Spain 0034).
“__64” NUMBER OF CONEXIONS OF THE COMPACT
It shows the number of times that the J-2000 has been switched on. This counter is
cleared after obtaining a RS232 ticket if address 4_24 is programmed to a value of 1.
“__65” PROTOCOL PROGRAMATION
In this address we can select if the compact is going to run under MDB or Executive
protocol. Has two possible values:
0: The compact is going to run under Executive protocol.
1: The compact is going to run under MDB protocol.
If content of this address is changed, when trying to exit this address the display will
show “----”. Then it’s necessary to switch off and on the compact and make a reset of
the compact to start running the new protocol selected on this address.
“__66” NUMBER OF PRICES CONTROLLED BY THE COMPACT
This address is only shown in the third level. The content of this address selects the
number of prices controlled by the compact in price retention mode. The compact can
control a number between 10 and 99 prices.
When the compact is controlling a number of prices greater than 10, the addresses
used to program prices and sales counts change in the next way:
Price programming:
-101-> In this address you can program the price 1.
..
-199-> In this address you can program the price 99.
Sales counts:
1201-> Partials counts of price 1.
To Next Page
Loading...
