MNP11M01GB06 May 2007- Rev.4 Page: 26 de 40
CHANGING THE CODE
If we want to restrict the access to options of the compact (count data, coins
programmed to tubes, etc.) we can program a new access code to the second level.
To change the code press “3”. In this moment the display will show the code
programmed at present. If you wish to modify it you must press “2”. The zero in digit 4
lights up again, and the new code can be introduced following the same procedure
that has already been explained to obtain access to the second level.
The “master” code is found in the appendix to the manual.
This second level allows access to all the addresses of the programming level, except
those that belong to the third level.
FROM THE MOMENT ACCESS IS OBTAINED TO THE 2nd LEVEL UNTIL THE
PROGRAMMING MODE IS LEFT, THE DECIMAL POINT SITUATED AT THE
RIGHT OF THE DISPLAY REMAINS LIT.
“__51” SELECTOR CHECK
0_51: Checking of coin recognition. Shows the route and the value of the coin
accepted. If the route is a tube, the display will show a number corresponding with the
sum of the values of the tubes where the coin is routed.
Tube 1: Has a value of 1.
Tube 2: Has a value of 2.
Tube 3: Has a value of 4.
Tube 4: Has a value of 8.
Tube 5: Has a value of 16.
For example, if when a coin is accepted the display shows a 6, the coin is
programmed on the tubes 2 y 3 (2+4 = 6).
If the coin will be routed to the cashbox the display will show 32.
1_51: Check of the coin acceptance. Only shows the value of the accepted coin.
“__52” TYPE OF PROTOCOL
If the compact is running under protocol MDB, two speeds of the protocol can be
programmed:
- MDB Protocol Þ 0.
- ICP Protocol Þ 1.
“__53” COINS IN EXTERIOR TUBES
Use this address to program the value of the coins in the exterior tubes.
1_53: Program the value of the coin in the exterior tube 1.
2_53: Program the value of the coin in the exterior tube 2.
“__55” NOTE READER OPTIONS
0_55: Note reader type.
1_55: Value of note 1.
....
7_55: Value of note 7.
To Next Page
Loading...
