MNP11M01GB06 May 2007- Rev.4 Page: 7 de 40
Refund slide:
This is the system that makes it possible to extract coins from the bottom of each
change tube by a claw. It also has two safety locks to avoid the accidental falling of
the coin in the tubes.
F Installation of the compact
Verify that the compact is installed vertically and that the refund lever of the validator
is not activated by the lever of the machine.
Connect power to the compact. Verify that the coins programmed on address 22
correspond with the size of the tubes. Verify too if the protocol programmed on
address 65 it is correct. If the communication is running correctly you can see the
points of the interior display flashing.
Introduce at least three coins in each tube through address 25, as indicated on page
18 of this manual.
Introduce a coin and carry out a purchase (repeat this process with different coins and
channels of the machine).
Unload coins from the tubes (address 26) and verify that they fall correctly into the
refund drawer.
To Next Page
Loading...