EasyManua.ls Logo

Jofemar J-2000 - Page 20

Jofemar J-2000
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MNP11M01GB06 May 2007- Rev.4 Page: 20 de 40
3_27: Photo-sensors of the tubes are covered:
1: Sensor of tube 1 is covered.
2: Sensor of tube 2 is covered.
4: Sensor of tube 3 is covered.
8: Sensor of tube 4 is covered.
16: Sensor of tube 5 is covered.
Errors of this address will be self cleared when the sensor is uncovered. Errors in this
address are normally caused by coins jammed at the top of the tube.
4_27: Shows the sum of the error codes in the coin validator. The possible error
codes are:
1: Photo -sensor or T10 coil broken.
2: Synchronism error.
5_27: Shows “1” if the refund motor is broken. If the compact is running under
executive protocol and the refund motor is broken when a refund is being made, the
compact changes to multiple vend to avoid clearing the credit that hasn’t been
refunded. When this error is marked, check the value of the address 2_30.
6_27: Shows “1” when a error is detected in the escrow system.
7_27: Shows the error code caused by a coin that has not followed the intended
routing. The value showed is the sum of the calculated route and the detected route.
The values of the tubes are:
1: For tube 1.
2: For tube 2.
4: For tube 3.
8: For tube 4.
16: For tube 5.
8_27: This field shows the breakdowns in the coils of the safety locks of the refund
trolley. If a safety lock is broken, the compact will also mark as broken the tubes
controlled by the lock.
1: Coil 1 broken-> Breakdown detected in the lock of tubes 1 and 2.
2: Coil 2 broken-> Breakdown detected in the lock of tubes 4 and 5.
3: Coil 1 and 2 broken-> Breakdown detected in the lock of tubes 1,2,4 and 5.
9_27: Shows error detected in the programming options of the compact:
1: Prices are unprogrammed.
2: Tokens are unprogrammed.
4: Notes are unprogrammed.
8: Programming options unprogrammed.
16: Coins to tubes are unprogrammed.
In program mode the address that has caused the deprogramming will be shown
flashing.
A_29: Shows the error in exterior tubes.
1: Error in exterior tube number 1.
2: Error in exterior tube number 2.

Related product manuals