Johnson Controls AD-1272 - Page 41

AD-1272 Advanced Thermal Dispersion Probe Airflow Measuring System Technical Bulletin
41
4. Press ESC or ENTER to return to the Sensor Management submenu.
5. Press UP or DOWN to scroll to the Scan for Sensors submenu selection. Press ENTER. When this option is
selected, the primary probe sends scan and restart commands to all ancillary probes on the wired probe
network. The primary probe then restarts to detect all probes and sensors and updates the inventory.
6. Press ENTER to scan for sensors.The primary probe provides scan and restart commands to the network.
7. Once the scan is complete, the display returns to the normal operation mode. Press MENU.
8. Press UP or DOWN to scroll to the Supervisor Menu. Press ENTER.
9. Press UP or DOWN to scroll to the Display Sensor Status submenu.
10. Press ENTER. The display indicates the following message:
11. Press UP or DOWN to scroll to the probe to display on line 1 of the display.
12. Press ESC. The display returns to the Sensor Management submenu.
Figure 70: Scan for Sensor Selection Screen
Figure 71: Scanning for Sensors Display Screen
Figure 72: Display Sensor Status Selection Screen
Figure 73: Sensor Status Display Screen