ZFR1800 Series Wireless Field Bus System Technical Bulletin 25
• Connect the ZFR1811 Router to the correct jack on the field controller. Refer
to the ZFR1811 Wireless Field Bus Router Installation Instructions
(Part No. 24-10325-10).
• Select PAN Addresses that are unique within the site.
• Select PAN Addresses that result in unique MS/TP addresses for each
ZFR1810 Coordinator on a trunk. We recommend that you set the PAN
addresses of multiple ZFR1810 coordinators on the same trunk sequentially to
guarantee that each ZFR1810 has a unique MSTP Address on the bus.Refer to
the ZFR1810 Wireless Field Bus Coordinator Installation Instructions (Part
No. 24-10325-2).
Note: Once the PAN has been selected and other devices start to join the network,
do not change the PAN switches to another value and then back again.
Changing the PAN switches causes that device to clear its network
information, resulting in abandoned children. This can lead to duplicate
network (short ) addresses and controller online/offline toggling.
To Next Page
Loading...