ZFR1800 Series Wireless Field Bus System Technical Bulletin 45
Network Maintenance
Use this section when you need to upgrade an existing ZFR1810 Coordinator,
replace an existing wireless component, or change the ZigBee channel.
Note: The default selection for the ZigBee channel is Automatic; however, the
ZigBee channel can be manually adjusted as described in this section.
Upgrading an Existing ZFR1810 Coordinator
You can upgrade the ZFR1810 Coordinator by using CCT to download the
MS-ZFR1810 Boot and Main code. Use the Wireless Commissioning Converter
(MS-BTCVT-1) while directly connected to the Bus Out port on the ZFR1810
Coordinator.
Note: You cannot use the Bus In port on the ZFR1810 Coordinator with the
Wireless Commissioning Converter because this port does not provide
power to the converter.
To upgrade an existing ZFR1810 Coordinator:
1. Identify the current version of the ZFR1810 Coordinator using one of the
following methods:
• Log on to the NAE/NCE supervisory engine, and view the focus window
of the MS-ZFR1810 object.
• In CCT, go to Tools > Controller Information, and select the MS-ZFR1810
from the list.
• In CCT (no application open), select Load and choose the Download To
Device option on the Connection screen of the Load wizard. Click Next.
After discovery finishes, select the MS-ZFR1810 to download from the list
on the Device Selection screen (this is the only device in the list), and click
Next. The Load Summary screen indicates the Model, Bootcode Version,
and Maincode Version of the MS-ZFR1810 device.
2. Upgrade the Boot and Main Code of the ZFR1810 Coordinator as follows:
a. In CCT (no application open), select Load. The Load wizard appears with
the Connection screen active.
b. Select the Download To Device option on the Connection screen of the
Load wizard and click Next.
c. After discovery finishes, select the MS-ZFR1810 to download from the list
on the Device Selection screen and click Next.
d. Select Boot and Main code on the Load Summary screen and click Finish.
Note: When upgrading from Release 4.0 to Release 4.1 using the Wireless
Commissioning Converter (MS-BTCVT-1) or passthrough, and
downloading both boot and main code, follow these steps if the main code
download fails:
To Next Page
Loading...
Need help?
General
