4-28
Main menu
Explanation Default
Sub-menu1
Sub-menu2
Sub-menu3
5> SENSOR Setting the GPS Sensor
GPS MODE
Select the GPS mode
【AUTO, GPS alone, Beacon, SBAS】
AUTO
FIX MODE Select the fix mode AUTO
【AUTO,2D,3D】
ELV MASK Select the elevation mask
【5～89 degrees】
5 deg
HDOP
Selecting the HDOP
・Positioning is only performed if HDOP is lower than
the set value
【4,10,20】
4
SMOOTHING
Smoothing can be applied to measured positions,
speeds, and courses.
・The higher the smoothing value, the smoother the
results will be, but the greater time lag. Conversely, if
the smoothing value is set low, a great number of
changes will occur, but there will be little time lag
-
POSITION
Smoothing can be set for position 【0～99sec】 10 秒
SPEED
Smoothing can be set for speed 【0～99sec】 10 秒
COURSE
Smoothing can be set for course 【0～99sec】 10 秒
RAIM ACCURACY
Set the RAIM accuracy level
【100,50,30,10,OFF】
100m
INITIALIZATION Initializing the GPS sensor
－
LATITUDE Set the initial position (Latitude)
－
LONGITUDE Set the initial position (Longitude)
－
HEIGHT Set the anntena height
－
DATE
Set the date
・Enter the current date in UTC
－
TIME
Set the time
・Enter the current time in UTC
－
SEND Perforing the initilization
－
BEACON Setting the DGPS positioning for beacon
－
STATION SELECT
Set the beacon station selection method
【AUTO,MANUAL】
AUTO
FREQUENCY
Set the frequency when station selection is set to
manual
－
BIT RATE Set the bit rate when station selection is set to manual
－
SBAS Setting the SBAS positioning
－
SBAS SEARCH
Select the SBAS satellite selection method
【AUTO,SBAS satellite number selecable】
AUTO
TYPE 0 INFO
Set whether type 0 information (test broadcast) data is
used
【ON(USE),OFF(Not USE)】
OFF
RANGING
Set whether SBAS satellite is used for positioning in
the same way as the GPS satellite.
【ON(USE),OFF(Not USE)】
OFF
8> BEACON
DISPLAY
Displaying the beacon information
【ON,OFF】
ON
To Next Page
Loading...
