JUKI HZL-F series - Adjusting the disk opening amount at the time of thread trimming; Adjusting the needle thread tension

20
Place the thread spool to the spool pin.
Winding the bobbin thread
* An exclusive motor is built-in for winding bobbin so that you can wind bobbin at any time.
3
4
Wind the thread to the bobbin 4-5 times in clockwise direction.
Spool pin
Thread guide
A
Bobbin winding shaft
1
2
Thread the guide
A
and then thread the thread guide (guide
in the circle) for bobbin winding.
Set the bobbin on the bobbin winding shaft.