21
5
7
Put the thread end into the guide at the bobbin winding shaft
and pull it to the right side to cut it.
Push the bobbin winding regulator towards the bobbin to start
winding the bobbin.
* Be careful that the bobbin winding regulator works as a switch.
6
When winding is nished, the shaft stops automatically, the
bobbin winding regulator moves to right and return to the original
position. Remove the bobbin from the bobbin winding shaft and
cut the thread by cutter.
* Bobbin winding will automatically stop even while winding, when the
winding speed is reduced due to a load to the bobbin winding motor
caused by thread tangling.
Bobbin winding regulator
Guide (with cutter)
Cutter
To Next Page
Loading...
