EasyManuals Logo

JUKI HZL-F series Instruction Manual

JUKI HZL-F series
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
58
Eyelet punch
Stopper pin
Unplug the sensor pin after sewing.
Opening the buttonhole using a ripper.
[double bartack]
Pierce a stopper pin at the bartack and open the buttonhole with a ripper.
Be careful not to cut the stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a hole with the eyelet
punch.Then pierce a stopper pin at the bartack and open the buttonhole
with a ripper.
Ripper
It will be easier to sew buttonholes on the thin fabrics and/or near the overlapped
sections, if the clamping plate is used.
1. Attach the buttonhole presser foot to the presser foot holder, with
the clamping plate together.
2. Place the fabric between the presser foot and the clamping plate.
* You can remove the clamping plate by holding
A
.
Clamping plate
Buttonhole clamping plate
A
6
7
Caution
Turn off the power when
setting the clamping plate.

Table of Contents

Other manuals for JUKI HZL-F series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JUKI HZL-F series and is the answer not in the manual?

JUKI HZL-F series Specifications

General IconGeneral
BrandJUKI
ModelHZL-F series
CategorySewing Machine
LanguageEnglish

Related product manuals