57
Place the fabric under the presser foot.
Raise the presser foot, pass the needle thread through the hole on the presser
foot and pull it out sideways.
Place the fabric under the presser foot, align the marking with the sewing-start
point. Penetrate the needle into the fabric by turning the hand wheel and lower
the presser foot.
Start sewing.
The machine will stop automatically after sewing the buttonhole.
* If a buttonhole of the same size will be sewn again, push the thread
trimming button to trim the threads and raise the presser foot. Under
this condition move to another point, lower the presser foot and then
start sewing.
* Do not change stitch length and/or zigzag width during buttonholing.
Otherwise this will cause imbalanced stitches.
* If thread trimming button is pushed while sewing buttonhole, the
machine will stop and will not complete the buttonhole.
* Depending on material to be sewn and weaving direction of the material,
there might be a slight difference in zigzag widths between right and left lines of
buttonholes. Test sewing is recommended.
Needle thread
Start from here
Marking
4
5
Hole on the
presser foot
Sewing-start point
To Next Page
Loading...
Need help?
General
