70
Teeth
Seam line
Basting
Zipper (back)
Slider
Fabric (wrong side)
0.7 to 1 cm
0.7 to 1 cm
Fabric (right side)
Zipper tape
Reverse stitches
Baste zipper and garment body.
Open the seam allowance. Fit the teeth of the zipper at the end of the seam
line and perform basting by hand. Pull the slider tab to the up side.
Sew the left part of the zipper on the seam allowance from the
bottom of the opening to the top.
Sew 0.7 to 1 cm from the seam line.
Sew the right part of the zipper.
Sew reverse stitches a few times.
Sew the other side 0.7 to 1 cm from the seam line.
Undo only the basting stitches.
Centered insertion
Set on right
Set on left
1
2
3
4
To Next Page
Loading...
Need help?
General
