JUKI LZ-2290C-F - Page 148

– 143 –
5) Setting other sewing data
󱀆
.
The type of sewing data displayed on the
"sewing data edit screen" changes according
to the step changeover reference selected in
the aforementioned item number 3. (See the
table shown below.)
<Sewing data edit screen>
The presser lifter operates after
thread trimming according to the
setting of the nal step.
Step changeover reference
Number of stitches Hand switch
Multi-layered part
detection
Step changeover sensor value
× × ○
Number of stitches
○ × ×
Stitch length
○ ○ ○
Reverse feed stitch length
○ ○ ○
Needle thread tension
○ ○ ○
Intermediate stop - Needle bar
stop position
○ ○ ○
Intermediate stop - Presser foot
lifting
○ ○ ○
Stop - Needle bar position
○ ○ ○
Stop - Presser foot lifting
○ ○ ○
Stop - Presser foot lifting height
○ ○ ○
One shot
○ ○ ○
Sewing speed limit
○ ○ ○
󱀆
󱀇