– 77 –
hh
hh
h
Simplified program setting (Function setting No. 66)
Valid/invalid of motion of simplified program, and input, change, etc, of program are set.
For the details, refer to “(2) of 9. How to use the simplified program function”.
jj
jj
j
Auto hemmer control changeover (Function setting No. 67)
Auto hemmer control used with MF is selected.
0 : Control 1
1 : Control 2
Contents of setting list
Control 1 Control 2 Remarks
At the time of turning • Air blow : OFF • Air blow : OFF
ON the power • Hemmer guide : OFF • Hemmer guide : OFF
• Presser lifter : ON (lifting) • Presser lifter : ON (lifting)
Depressing the back • Presser lifter comes down by • Air blow : ON
part of pedal depressing pedal • Hemmer guide : ON
(When it is shallowly • Air blow : ON • Presser lifter : ON (lifting)
depressed) • Hemmer guide : OFF • When pedal is returned to neutral position,
Aforementioned motions are
air blow and presser lifter are OFF (lowering).
alternately repeated by shallowly • Hemmer guide is not OFF until overlapped
depressing the back part of pedal.
section sensor detects after making hemmer
guide output once ON.
kk
kk
k
Prohibition of start with material end sensor of auto hemmer control (Function setting No. 68)
Setting whether starting sewing machine or not with material end sensor of auto hemmer control used with MF is
performed.
0 : Invalid (Sewing machine is started regardless of detection of material end
sensor.)
1 :Valid (Sewing machine is not started in case of detection of material end
sensor.)
ll
ll
l
Selection of speed control method after detection of material end sensor of auto hemmer control (Func-
tion setting No. 69)
Setting whether by manual or automatic the speed control after detection of material end sensor of auto hemmer
control used with MF is possible.
0 : Pedal depressing amount
1 : Setting speed (Motion with setting speed of function setting No. 38)
;;
;;
;
Number of stitches of invalid material end sensor of auto hemmer control (Function setting No. 70)
Setting of number of stitches which makes invalid detection of material end sensor of auto hemmer control used
with MF can be set.
0 : Invalid
Setting range 1 to 500 [Unit : 0.5 stitch]
zz
zz
z
Clutch motor function (Function setting No. 72)
This function makes valid the function which performs same motion as clutch motor.
0 : Invalid
1 : Valid
When this function is set to valid, UP/DOWN stop function by synchronizer or the like attached after set-up of the
machine does not work, and only rotation stop motion by depressing pedal works.
To Next Page
Loading...
