JUKI SC-510 Series - 7. CONNECTING PROCEDURE WITH JUKI OPTIONAL DEVICE; (1) Connection of the pedal of standing-work machine

– 78 –
xx
xx
x Retry function (Function setting No. 73)
When the retry function is used, if the sewing material is thick and not pierced with needle, this function makes
the needle pierce in the material with ease.
0 : Normal
1 : Retry function is provided.
cc
cc
c With/without MF thread trimming device (Function setting No. 74)
This function sets with or without the MF thread trimming device (UT-25, etc.).
0 : Without device
1 : With device (Initial value)
vv
vv
v One-shot function up to material end (Function setting No. 76)
This function can perform the one-shot automatic stitching up to the end of material in combination with the
material end sensor when the operation panel is not connected.
0 : Without one-shot function
1 : With one-shot function
bb
bb
b Reverse feed stitching at the end of sewing start time (Function setting No. 85)
Time to run the machine at specified speed to gain back-tuck solenoid response time when moving from end of
normal sewing to reverse feed stitching is set.
0 : Invalid
Setting range 1 to 250 [mS]
Time to maintain setting No. 64 (number of rotations of start
of reverse feed stitching at the end) immediately after en-
tering back-tuck is set as shown in the right-hand figure.
nn
nn
n Waiting time of start of reverse revolution to lift needle (Function setting No. 86)
Delay time from UP stop position to start of reverse revolution can be set.
0 : Invalid
Setting range 1 to 250 [mS]
mm
mm
m Function of pedal curve selection (Function setting No. 87)
This function can perform the selection of the curve of number of rotation of the sewing machine against the
depressing amount of the pedal.
Change to this function when you feel that inching operation is hard or that pedal response is slow.
0 :Number of rotation of the sewing
machine in terms of the depress-
ing amount of the pedal in-
creases linearly.
1 : Reaction to intermediate speed
in terms of the depressing
amount of the pedal is delayed.
2 : Reaction to intermediate speed
in terms of the depressing
amount of the pedal is advanced.
,,
,,
, Initial UP stop position move function (Function setting No. 90)
Whether valid or invalid of function to automatically return to UP stop position immediately after turning ON the
power can be set.
0 : Invalid
1 : Valid
Pedal sroke (mm)
Number of rotstion (rpm)
2
0
1
1
7
3
0
7
6
0
8
7
0
1
8
5
Time of this section where
back-tuck enters is set
0
1
8
6
0
9
0
1
7
4