Safety notes for the user
18
2. Safety notes for the user
In addition to the safety warnings listed above, warnings are posted
throughout the manual. These warnings are designated by an exclamation
mark inside an equilateral triangle. „Warning of a dangerous situation
(Attention ! Please follow the documentation).“
The danger is described according to an alarm keyword.
Read and follow these important instructions.
Warning:
Describes a possibly highly dangerous situation. If this is not avoided,
serious injury and danger to life could result.
Caution:
Describes a possibly dangerous situation. If this is not avoided, slight or
minor injuries could result.
A warning of possible damage can also be contained in the text.
Notice:
Describes a possibly harmful situation. If this is not avoided, the product
or anything in its surroundings can be damaged.
3. Preparations
3.1. Installation
• Place the unit on an even surface on a pad made of non-flammable
material.
F34-MC: The circulator fitted with a stainless steel bridge is placed
on on the back of the bath tank leaving the bath open on the front
side.
• Set selector dial for cooling machine (19) in position "1" for
operation with MC circulator.
(only F25, F26, F34)
• Keep at least 20 cm of open space on the front and rear venting grids.
• Do not set up the unit in the immediate vicinity of heat sources and
do not expose to sun light
• Before operating the unit after transport, wait about one hour after
setting it up. This will allow any oil that has accumulated laterally
during transport to flow back down thus ensuring maximum cooling
performance of the compressor.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
