35
3 Operator level (visualization)
The first line of the activated batch report that has been configured for text
input via bar code will automatically be filled with the text that corresponds to
the bar code. If several line have been configured for bar code activation, then
they will be processed one after another, from top to bottom.
Reset entry Execution of the following bar code will reset the activation of the batch texts.
The standard (default) texts (parameter Factory setting) will be displayed, and
the first line will be prepared for input.
Summary of the
bar codes
All the bar codes that are required are also collected together in the appendix
of the operating manual B 70.6580.0.
The codes for batch control (BATCH1, BATCH2, BATCH3, START,
STOP, RESET) cannot be used for setting batch texts.
To Next Page
Loading...
