4.2
Charging the battery with an on-board charger (o) 57
5 Battery removal and installation 65
5.1 Changing the battery from the top 66
5.2 Removing the battery from the side 68
.
E Operation 73
.
1 Safety Regulations for the Operation of Forklift Trucks 73
2 Displays and Controls 75
2.1 Battery discharge monitor 79
2.2 Battery discharge indicator 80
3 Preparing the Truck for Operation 81
3.1 Checks and Operations to Be Performed Before Starting Daily Work 81
3.2 Preparing the truck for operation 82
3.3 Checks and operations to be carried out when the truck is operational 83
3.4 Parking the truck securely 84
4 Industrial Truck Operation 85
4.1 Safety regulations for truck operation 85
4.2 Emergency Disconnect 87
4.3 Automatic braking 89
4.4 Travel 90
4.5 Slow travel 93
4.6 Steering 94
4.7 Brakes 94
4.8 Load handler raise/lower 97
4.9 Lifting, transporting and depositing loads 100
4.10 Use as a Lift Work Table 108
5 Troubleshooting 109
5.1 Truck does not start 110
5.2 Load cannot be lifted 112
6 Operating the truck without its own drive system 113
6.1 Release and activate the drive wheel brake 113
7 Load handler emergency lowering 115
7.1 EJC 214/216/220 115
7.2 EJC 212z / 214z / 216z / 220z 116
8 Optional equipment 117
8.1 Emergency operation with service key GF60 117
8.2
CanCode Keypad (o) 119
8.3 Setting the truck parameters with CanCode 138
8.4 Parameters 140
8.5 Setting the Battery Parameters with CanCode 145
8.6 Set ELH 2415 / 2425 / 2435 Charger Characteristics with CanCode 147
8.7
CanDis Display Instrument (o) 149
8.8 Display unit (2 inch display) 151
8.9 Keyless Access System 156
8.10 General Information about the Use of Keyless Access Systems 157
8.11 Commissioning the Keypad and the Transponder Reader 157
8.12 Using the Display: 160
8.13 Using the Keypad 165
8.14 Operating the transponder reader 170
8.15
ISM access module (o) 174
8
04.19 en-GB
To Next Page
Loading...
Need help?
General
