To Next Page

To Previous Page

C 1

0205.GB

C Transport and Commissioning

1 Lifting by crane

Only use lifting gear with sufficient capacity (for truck weight see truck data plate,

chapter B).

– Park the truck securely (see Chapter E).

– Attach the crane slings to the strap point (1) so that the truck cannot slip.

2 Commissioning

Operate the truck only with battery current. Rectified AC current will damage the

electronic components. The battery leads (tow cable) must be less than 6m long.

When the truck is parked, the running surface of the tyres will flatten. The flattening

will disappear after a short time operating the truck.

To prepare the truck after delivery or after transport, proceed as follows:

– Check the truck is completeness and the equipment is in a satisfactory condition.

– Install battery (where required). Do not damage battery cable.

– Charge the battery (see Chapter D).

– If necessary, check that the setting of the battery discharge monitor or combination

instrument matches the battery type (see Chapter D).

Commission the truck in accordance with instructions (see Chapter E).

C 1