To Next Page

To Previous Page

D 7

0205.GB

6 Battery removal and installation

The truck must be level. To prevent short circuits, batteries with exposed terminals or

connectors must be covered with a rubber mat. Place the battery connector or the

battery cable in such a way that they will not get caught on the truck when the battery

is removed.

When transporting batteries using a crane, ensure that the crane is of adequate

capacity (the battery weight is indicated on the battery data plate on the battery

container). The crane lifting gear must exert a vertical pull. The hooks of the lifting

gear must never fall into the battery cells.

– Expose the battery (see Section 4).

– Remove the battery connector (4).

– Strap the crane lifting gear to the eyes (9).

– Pull the battery up out of the container.

Installation is the reverse order. When reinstalling the battery, note the proper

installation position and make sure the battery is connected correctly.

– After installing the battery again, check all cables and plug connections for visible

signs of damage.

Close the battery panel carefully and slowly.

Do not reach between the battery panel and the chassis.

D 7