To Next Page

To Previous Page

0205.GB

D 6

– Remove the connector (8) from the socket and store the mains cable back under

the battery panel.

Charging continues automatically after a mains failure.

Charging can be interrupted by removing the mains connector and continued as

partial charging.

The mains cable must not be opened.

Before starting the truck, the battery panel must be firmly closed.

Charging times

The duration of charge depends on the battery capacity.

LED display

Compensation charge

Compensation charge starts automatically when charging is complete.

Partial charging

The charger is designed to automatically adapt to partially charged batteries. This

keeps battery wear to a minimum.

Green LED

(charge status)

Red LED

(fault)

Display

Lit --- Charging complete, battery full. (Charging interval,

compensation charge)

Flashes slowly --- Charging

Rapid flash --- Display at beginning of charge or after setting a new

characteristic curve. Number of flash pulses

corresponds to the characteristic curve set.

--- Lit Overtemperature. Charging is interrupted.

--- Flashes slowly Safety charging time exceeded. Charging is

cancelled. Mains must be disconnected for charging

to recommence.

--- Rapid flash Invalid characteristic curve setting.

--- --- Mains failure and/or no battery connected.