Jungheinrich EJD K18 User Manual

0205.GB
E 6
4.2 Travelling, Steering, Braking
F
Never carry passengers.
Emergency Disconnect
– Remove the battery connector (14).
All electrical functions are deactivated.
Automatic braking
Automatic braking occurs when the tiller is released – the tiller automatically sets itself
to the upper brake zone (B).
F
If the tiller moves slowly to the upper brake zone, the cause of this fault must be
rectified. If necessary, replace the gas pressure spring.
Travel
M
Do not drive the truck unless the panels are closed and properly locked.
– Start up the truck (refer to section 3).
The travel speed is governed by the travel switch (10).
– Set the tiller (5) to the travel range (F) and press the controller (9) in the desired
direction (fwd. or rev.).
Crawl speed
F
The driver must be particularly careful when applying the “Crawl speed” switch (6).
The truck can be operated with a vertical tiller (5) (e.g. in congested areas / travel
seat).
– Press the crawl speed button (6).
– Set the controller (9) to the required direction (fwd. or rev.).
The brake is released. The truck travels at slow speed.
M
The brake is only activated with the crawl speed button is released; with crawl speed
you can only brake by plugging (controller (9)).
0205.GB
E 6
4.2 Travelling, Steering, Braking
F
Never carry passengers.
Emergency Disconnect
– Remove the battery connector (14).
All electrical functions are deactivated.
Automatic braking
Automatic braking occurs when the tiller is released – the tiller automatically sets itself
to the upper brake zone (B).
F
If the tiller moves slowly to the upper brake zone, the cause of this fault must be
rectified. If necessary, replace the gas pressure spring.
Travel
M
Do not drive the truck unless the panels are closed and properly locked.
– Start up the truck (refer to section 3).
The travel speed is governed by the travel switch (10).
– Set the tiller (5) to the travel range (F) and press the controller (9) in the desired
direction (fwd. or rev.).
Crawl speed
F
The driver must be particularly careful when applying the “Crawl speed” switch (6).
The truck can be operated with a vertical tiller (5) (e.g. in congested areas / travel
seat).
– Press the crawl speed button (6).
– Set the controller (9) to the required direction (fwd. or rev.).
The brake is released. The truck travels at slow speed.
M
The brake is only activated with the crawl speed button is released; with crawl speed
you can only brake by plugging (controller (9)).

Jungheinrich EJD K18 Specifications

General

Brand	Jungheinrich
Model	EJD K18
Category	Forklifts
Language	English