Jungheinrich EJD K18 User Manual

0205.GB
E 12
Starting the truck for the first time
The LED (15) goes red when you connect the battery and if necessary switch on the
key switch.
When you enter the correct operator code (factory setting 2-5-8-0) the LED (15) turns
green.
If the wrong code is entered LED (15) flashes red for two seconds. The correct code
can then be entered.
Z
The Set switch (16) has no function in operating mode
Switching off
To switch the truck off, press the o switch
(20).
Z
The truck can switch off automatically after a
pre-determined time. To do this, you need to
set the corresponding code lock parameter.
(see Section 5.4).
5.2 Parameters
In programming mode you can set the code
lock functions via the keypad. In addition, the
battery parameters can also be set.
Z
For trucks without display instrument (CANDIS (o)) only the code lock parameters
can be set.
Parameter Groups
The parameter number is composed of three digits. The first digit refers to the
parameter group as shown in Table 1. The second and third digits are numbered in
sequence from 00 to 99.
No. Parameter Group
0xx Code Lock Settings
(Codes, automatic cutout, etc.)
4xx Comments
1 2 3
4 5 6
7 8 9
0
Set
17
16
15
20
1918
0205.GB
E 12
Starting the truck for the first time
The LED (15) goes red when you connect the battery and if necessary switch on the
key switch.
When you enter the correct operator code (factory setting 2-5-8-0) the LED (15) turns
green.
If the wrong code is entered LED (15) flashes red for two seconds. The correct code
can then be entered.
Z
The Set switch (16) has no function in operating mode
Switching off
To switch the truck off, press the o switch
(20).
Z
The truck can switch off automatically after a
pre-determined time. To do this, you need to
set the corresponding code lock parameter.
(see Section 5.4).
5.2 Parameters
In programming mode you can set the code
lock functions via the keypad. In addition, the
battery parameters can also be set.
Z
For trucks without display instrument (CANDIS (o)) only the code lock parameters
can be set.
Parameter Groups
The parameter number is composed of three digits. The first digit refers to the
parameter group as shown in Table 1. The second and third digits are numbered in
sequence from 00 to 99.
No. Parameter Group
0xx Code Lock Settings
(Codes, automatic cutout, etc.)
4xx Comments
1 2 3
4 5 6
7 8 9
0
Set
17
16
15
20
1918

Jungheinrich EJD K18 Specifications

General

Brand	Jungheinrich
Model	EJD K18
Category	Forklifts
Language	English