To Next Page

To Previous Page

0205.GB

E 20

6.4 Troubleshooting

If the fault cannot be rectified after carrying out the remedial procedure, notify the

manufacturer’s service department, as any further troubleshooting can only be

performed by specially trained and qualified service personnel.

Fault Possible cause Action

Truck does

not start.

– Battery connector not

connected

– Check the battery connector and connect

if necessary

– Key switch in “0”

position

– Set key switch to “I”

– Incorrect CANCODE

code

– Check code

– Battery charge too low – Check battery charge, charge battery if

necessary

– Faulty fuse – Check fuses F1 and 1F1

– Truck in charge mode – Interrupt charging

Load cannot

be lifted

– Charge capacity below

20 / 40%

– Charge battery

– Truck not operational – Carry out all measures listed under

“Truck does not start”

– Hydraulic oil level too

low

– Check the hydraulic oil level

– Faulty fuse – Check fuse 2F1