To Next Page

To Previous Page

0206.GB

E 20

Picking up a load from the front

– Drive the truck at creep speed.

– Slowly insert the forks into the pallet

until the fork back touches the load or

the pallet.

– Raise the load slightly and reverse the

truck slowly (creep speed).

The ground surface must be in good

condition to ensure this works correctly.

Transporting loads

– Always transport a load outside the

rack aisle as low as possible, allowing

for ground clearance.

– Always transport loads with both forks. When transporting heavy loads always

ensure that both forks carry the same weight.

– Gradually accelerate the truck.

– Travel at a constant speed.

– Always be prepared to brake. Only stop suddenly in dangerous situations.

– Reduce speed accordingly on narrow bends.

Placing loads

– Drive the truck carefully up to the storage location

Before a load can be placed, the driver must ensure that the storage location is

suitable for storing the load (size and capacity).

– Raise the load lifting device so that the

load can be taken to the storage

location without striking any objects.

– Carefully set the load into its storage

location.

– Carefully lower the load lifting device

so that the forks are clear of the load.

Avoid placing the load down suddenly to

avoid damaging the load and the load

lifting device.Carefully remove the load

lifting device from the load.

– Fully lower the load lifting device.