4.8.1 Raising a load
Requirements
– Load correctly palletised.
– Load weight matches the truck's capacity.
– Forks evenly loaded for heavy loads.
Procedure
• Drive the truck carefully up to the pallet.
• Slowly insert the forks into the pallet until the
fork shank touches the pallet.
Z
The load must not extend by more than 50
mm beyond the fork tips.
• Press the “Lift” button (39) button until you reach the desired lift height.
The load is raised.
4.8.2 Transporting a load
Transporting loads
Requirements
– Load raised correctly.
– Mast lowered for transport (approx. 150 - 200 mm above the ground).
– Good ground conditions.
Procedure
• Accelerate and decelerate with care.
• Adapt your travel speed to the conditions of the route and the load you are
transporting.
• Travel at a constant speed.
• Watch out for other traffic at crossings and passageways.
• Always travel with a lookout at blind spots.
WARNING!
Do not negotiate slopes or inclines.
45
04.16 en-GB
To Next Page
Loading...
Need help?
General
