4.8.3 Depositing a load
Depositing loads
NOTICE
Loads must not be deposited on travel or escape
routes, in front of safety mechanisms or plant
equipment that must be accessible at all times.
Requirements
– Storage location suitable for storing the load.
Procedure
• Drive the truck carefully up to the storage location.
• Apply the "lower" button (38) until the forks are clear of the load.
Z
Do not set down the load abruptly in order to avoid damaging the load and the
load handler.
• Carefully remove the forks from the pallet.
The load is deposited.
5 Troubleshooting
This chapter enables the operator to localize and rectify basic faults or the results of
incorrect operation himself. When trying to locate a fault, proceed in the order shown
in the remedy table.
Z
If, after carrying out the following remedial action, the truck cannot be restored to
operation or if a fault in the electronics system is displayed with a corresponding
error code, contact the manufacturer’s service department.
Troubleshooting must only be performed by the manufacturer’s customer service
department. The manufacturer has a service department specially trained for these
tasks.
In order for customer services to react quickly and specifically to the fault, the
following information is essential:
- Truck serial number
- Event message from the display unit (if applicable)
- Error description
- Current location of truck.
46
04.16 en-GB
To Next Page
Loading...
Need help?
General
