Juniper EX4100 User Manual

3. Insert the cable connector into the opcal transceiver (see Figure 98 on page 153).
Figure 98: Connect a Fiber-Opc Cable to an Opcal Transceiver Installed in a Device
g000704
Transceiver
Fiber-optic
cable
4. Secure the cables so that they do not support their own weight. Place excess cable out of the way in
a neatly coiled loop. Placing fasteners on a loop helps cables maintain their shape.
CAUTION: Do not bend ber-opc cables beyond their minimum bend radius. An arc
smaller than a few inches in diameter can damage the cables and cause problems that
are dicult to diagnose.
Do not let ber-opc cables hang free from the connector. Do not allow fastened
loops of cables to dangle, which stresses the cables at the fastening point.
Congure Junos OS on an EX4100 and EX4100-F
Switch
IN THIS SECTION
EX4100 and EX4100-F Default Conguraon | 154
Connect and Congure an EX4100 and EX4100-F Switch | 170
Revert to the Default Factory Conguraon on an EX Series Switch | 175
153

Juniper EX4100 Specifications

General

Brand	Juniper
Model	EX4100
Category	Switch
Language	English