Juniper EX4100 - Configure Junos OS on an EX4100 and EX4100-F Switch; EX4100 and EX4100-F Default Configuration

EX4100 and EX4100-F Default Conguraon
Each EX Series switch is programmed with a factory default conguraon that contains the values set
for each conguraon parameter when the switch is shipped. The default conguraon le sets values
for system parameters such as syslog and commit, congures Ethernet switching on all interfaces, enables
IGMP snooping, and enables the LLDP and RSTP protocols.
NOTE:
• The factory default conguraon le has more interfaces for models that have more ports.
• The poe statement does not appear for models without PoE+ ports.
When you commit changes to the conguraon, a new conguraon le is created. This le becomes
the acve conguraon. You can always revert to the factory-default conguraon. See "Revert to the
Default Factory Conguraon on an EX Series Switch" on page 175.
The following is the factory-default conguraon le for an EX4100-48P switch:
system {
commit {
factory-settings {
reset-chassis-lcd-menu;
reset-virtual-chassis-configuration;
}
}
services {
ssh;
netconf {
ssh;
rfc-compliant;
yang-compliant;
}
}
auto-snapshot;
syslog {
file interactive-commands {
interactive-commands any;
}
file messages {
154