Juniper EX4100

10. If you are not replacing the power supply, install the cover panel over the slot.
Figure 104: Remove a DC Power Supply from an EX4100 Switch
Maintain Transceivers
IN THIS SECTION
Remove a Transceiver | 190
Install a Transceiver | 193
Remove a Transceiver
Before you remove a transceiver from a device, ensure that you have taken the necessary precauons
for the safe handling of lasers (see Laser and LED Safety Guidelines and Warnings ).
Ensure that you have the following parts and tools available:
• An anstac bag or an anstac mat
• Rubber safety caps to cover the transceiver and ber-opc cable connector
• A dust cover to cover the port or a replacement transceiver
190