9. Place the accessory box vertically by the rear end of the chassis in the shipping
carton.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing EX4500 Switch Components for Shipping
To pack the switch components, follow the instructions here.
Ensure that you have the following parts and tools available:
■ Antistatic bag, one for each component
■ Electrostatic discharge (ESD) grounding strap
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
To pack the switch components:
■ Place individual components in antistatic bags.
■ Use the original packing materials if they are available. If the original packing
materials are not available, ensure the component is adequately packed to prevent
damage during transit. The packing material you use must be able to support
the weight of the component.
■ Ensure that the components are adequately protected by wrapping them well
with packing materials. Pack the component in an oversized box (if the original
box is not available) with extra packing material around the unit so that the
component is prevented from moving around inside the box.
■ Securely tape the box closed.
■ Write the RMA number on the exterior of the box to ensure proper tracking.
Related Topics Returning an EX4500 Switch or Component for Repair or Replacement on
page 135
■
■ Unpacking an EX4500 Switch on page 64
142 ■ Packing EX4500 Switch Components for Shipping
Complete Hardware Guide for EX4500 Ethernet Switches
To Next Page
Loading...
Need help?
General